BroadMax Technology LinkMAX HSA300 Manuel d'utilisateur télécharger pdf (Page 37)

LinkMAX



 HSA300 User Manual

Configuring the LAN IP Address

The LAN IP address identifies the LAN port (eth-0) as a node on

your network; that is, its IP address must be in the same subnet as

the PCs on your LAN.

Definition

A network node can be thought of as any interface where a

device connects to the network, such as HSA300’s LAN port and

the network interface cards on your PCs. See Appendix 0 for an

explanation of subnets..

You can change the default to reflect the set of IP addresses that

you want to use with your network.

If your network uses a local DHCP server (other than the

ADSL/Ethernet router) to assign IP addresses, you can configure

the device to accept and use a LAN IP address assigned by that

server. In this mode, the ADSL/Ethernet router is considered a

DHCP client of your DHCP server.

Note

HSA300 itself can function as a DHCP server for your LAN

computers, as described in Chapter 5, but not for its own LAN

port.

Follow these steps to change the default LAN IP address or to

configure the LAN port as a DHCP client.

1. Log into Configuration Manager, and then click the LAN tab.

The LAN Configuration page displays, as shown in Figure 16.

Figure 16. LAN Configuration Page

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 143 144

Pas de commentaire

BroadMax Technology LinkMAX HSA300 Manuel d'utilisateur Page 37